BIXOLON SRP-E302 driver download and receipt troubleshooting

2026-11-16BIXOLON · SRP-E302

If the SRP-E302 stops printing or clips receipt lines, check the full model name on its label and run a printer self-test first.

Official SRP-E302 driver download

On the BIXOLON download page, open Driver. The listing shows POS Windows Driver V5.2.3 for a standard Windows print queue. BIXOLON lists 32-bit and 64-bit Windows 7, 8, 8.1 and 10, plus 64-bit Windows 11. The Windows 11 listing gives no separate ARM64 installer. For macOS or Linux, choose the CUPS Driver POS V1.5.9 entry for your system. Use OPOS or JavaPOS when your POS application requires that interface.

Open BIXOLON downloads

Check the 203 dpi model and its ports

The base SRP-E302 uses USB. The SRP-E302ES has USB, wired Ethernet and a 9-pin serial port. When nothing prints, match the queue to the cable actually in use.

Check receipt lines after moving an SRP-E300 setup

With the printer’s default built-in fonts, the E302 fits 48 Font A characters or 64 Font B or C characters per line. The E300 fits 42 or 56, respectively. If a fixed-column receipt shifts after the change, select the E302 queue, check the font and column count in your POS template, and print one receipt to verify the layout.

The thermal roll is 79.5 ± 0.5 mm wide and the printable area is 72 mm wide. For a clipped right edge, check the driver or POS paper size and margins, then fit the receipt content within the printable width.

SRP-E300 180 dpi guide

Run the FEED self-test on the printer

  1. Load paper, close the top cover and turn the printer off.
  2. Hold FEED while turning the printer on. The printer prints its settings and ROM version, then the ERROR light blinks while it waits for your next input.
  3. Press FEED for less than one second after the settings print. The printer prints a completion line, cuts the paper and returns to normal printing. Holding FEED for at least one second opens the memory switch menu.

ERROR light and paper jams

If ERROR lights during normal use, check the roll and top cover. Switch the printer off and let the head cool before replacing the roll. Leave a small length of paper outside and press the center of the cover to close it.

For a jam, switch the printer off and on to see whether the cutter returns to its starting position. If the cover opens, remove the crumpled paper. If it stays locked, avoid forcing it. Turn the printer off and consult the cutter diagram on page 29.

If the self-test passes and only POS printing fails, match the POS queue to the actual connection and check the driver for this model. Check the SRP-E302 driver

Official BIXOLON sources