Brother TD-2350D driver download, label feed errors and calibration

2026-11-17Brother

Choose the driver for your operating system

Open official Brother TD-2350D downloads

Brother uses the TD-2350D support entry for the TD-2350D203 and TD-2350D300. Select your operating system and look for Printer Driver. The Windows 11 listing lists 1.17.0b, dated September 30, 2026. P-touch Editor is for label design. Printer Setting Tool is a separate download for device and paper settings.

For USB-C setup, use a data cable and connect it when the installer prompts you. Brother’s USB setup instructions · For a network queue, use the settings report to identify the wired or wireless connection you intend to use and select that printer during setup.

Match the unit label and connection

The TD-2350D203 prints at 203 dpi and the TD-2350D300 at 300 dpi. Check the model label against the resolution used in your label layout. Both are direct thermal and Brother lists USB-C, wired Ethernet, Wi-Fi and Bluetooth. The USB host port serves peripherals such as scanners and keyboards. Use the USB-C port for a computer connection.

What to check when labels misfeed or do not print

Check media selection and calibrate the roll

If the printer runs out of media or cannot find the start of the next label, read the LCD first. In the TD-2350D/TD-2350DF LED table, feed errors and media end share a pattern in which the Roll and Status LEDs each alternate one second off and one second on. Check the label supply, the paper position at the sensor and whether the cover is latched.

  1. After changing label stock, check Menu → Media → Selection on the printer.
  2. With the roll installed correctly, open Menu → Media → Calibration and press OK for each selection. The printer applies the media information it detects.
  3. If the computer still sends a different size, compare it with Paper Size Setup in Printer Setting Tool. Match the size in the printing app and try one label.

For an open cover, close the roll compartment until it latches. If the unit has a cutter and shows Cutter error, Brother directs you to hold the power button to turn off the printer. Check the fitted option and the LCD message, then use Brother support if the error persists.

Print a settings report without a computer

Turn the printer on and load a supported roll at least 58 mm wide. Choose Menu → Information → Print Configuration → Printer Settings, confirming the selections with OK. The report includes device settings and wired and wireless network information.

If the report prints but a computer job fails, compare the computer queue’s model and connection, then check the driver downloads for this model. If you set up both USB and networking, check which queue the app is using before changing any settings.

Official references

203 dpi product · 300 dpi product · Downloads by operating system · Media calibration · Settings report · Printing and feed problems · Error and maintenance LEDs