CL-E303 driver downloads
Choose CL-E303 and your operating system in Citizen Drivers & Tools. For Windows 10 or 11, the selected model page lists Windows Driver 11.11.0. Review the manufacturer’s download terms and follow the installer’s connection instructions.
Open Citizen CL-E303 driversThe same page lists Linux CUPS and macOS CUPS drivers. Check the selected package for OS version and CPU requirements, particularly Windows on ARM and Apple silicon. Label Printer Utility changes printer settings. Use the print driver for the print queue.
Connections and label stock
Citizen lists USB 2.0, 10/100 Ethernet and RS-232C for the CL-E303. Match the queue to the physical connection. For Ethernet, compare the queue address with the printer’s current address shown by Citizen Network Seeker. For serial jobs, match the computer and printer’s baud rate, data bits, parity and stop bits.
Use direct thermal stock. Check both sides of the lid are latched. Align the movable sensor with the label gap or the printed black mark, as shown in the manual. Select the gap sensor for labels on backing, the reflective black mark sensor for marked stock, or continuous media detection for unmarked continuous stock.
Print a test label from the printer
A built-in test uses the stock already loaded and helps separate feed or print quality issues from the computer’s queue.
- Close the lid. Hold FEED while turning the printer on to enter special function mode. The indicator alternates green and red and the buzzer gives three short tones.
- Press FEED twice for Test print mode. Look for fast green flashes and two short tones. Hold FEED for at least three seconds and release it at the long tone.
- Use FEED to choose label stock (one short tone) or continuous stock (two short tones). Hold FEED again for at least three seconds and release at the long tone to start printing.
- Turn the printer off and on after the test to return to normal operation.
Use the status light and beep pattern
- Red flashes, 2 short tones
- Close the top cover and confirm both latches are engaged.
- Red flashes, 3 short tones
- Check whether the roll ran out or was loaded incorrectly. Reseat it and check the paper path.
- Red flashes, 4 short tones
- Check for a jam and confirm the sensor position and media mode match the stock. See media and sensors.
- Red flashes, 6 short tones
- On a cutter or peeler model, check which option is fitted. If the error persists after the manufacturer’s checks, contact the dealer.
- Red and green alternate, repeated long tones
- For a serial connection, compare the RS-232C settings on both sides. The manual groups parity, framing and buffer faults under this signal.
If the test label prints correctly and only computer jobs fail, check for a paused queue, the correct printer port and the label size in the app. If the wrong model is installed, use the CL-E303 driver downloads.