Citizen CL-E331 driver download and ribbon troubleshooting

Set up the 300 dpi CL-E331 for thermal transfer or direct thermal printing. A built-in test helps diagnose blank labels, ribbon errors and feed problems.

CL-E331 driver downloads

Citizen lists Windows Driver 11.11.0 for Windows 10 and 11, plus CUPS drivers for macOS and Linux. Verify your OS version and CPU support in the manufacturer's package details. VCOM Driver is for a virtual COM port, and Label Printer Utility configures the printer. Choose the print driver for your operating system to set up a print queue.

Open official Citizen CL-E331 drivers

Check the 300 dpi model and print method

Check that the nameplate says CL-E331. It has USB 2.0, 10/100 Ethernet and RS-232C as standard. Select the queue for the fitted 300 dpi head and the port you actually use. For Ethernet, check the printer’s current address. For RS-232C, match communication settings at the printer and host.

Select DT for direct thermal stock or TT for thermal transfer stock with a ribbon. Use the transmissive sensor for gaps or notches, the reflective sensor for black lines on the back, and continuous media detection for unmarked continuous stock.

Check the ribbon for blank labels or ribbon errors

For thermal transfer, use an ink-side-out ribbon. Fully seat the shafts in the supply roll and empty take-up core, then fasten the ribbon end to the core. With both shafts fitted, turn the take-up flange in the direction shown in the manual to remove slack.

Close both inner ribbon covers and check that both top-cover latches engage. If the ribbon does not wind, recheck its path and winding direction. If it still wrinkles during a thermal-transfer test print, use the manual’s left-to-right balance check.

Ribbon-loading diagrams, pp. 60–66

Run a test print from the printer

This built-in test checks feeding and print quality without a PC print job. Load the stock and ribbon required by your print method first.

  1. Start with the printer off. Hold FEED while switching it on to enter special function mode.
  2. Tap FEED twice for test print mode. Check for two short tones and a fast green flash, then hold FEED for at least three seconds and release it when the long tone sounds.
  3. Use FEED to select the loaded stock. One short tone means label media and two mean continuous media. Hold FEED again for at least three seconds and release it at the long tone to print.
  4. After the test, switch the printer off and back on to return to normal mode.

User manual, pp. 114–115

Match the status light and buzzer

Flashing red · 2 short tones
Check that both top-cover latches are engaged.
Flashing red · 3 short tones
The printer is out of media or the roll is loaded incorrectly. Refill or reload it.
Flashing red · 4 short tones
Check for a physical jam. If the path is clear, match the sensor mode and position to gap, black-mark or continuous stock.
Flashing red · 5 short tones
The ribbon is empty or incorrectly fitted. Replace it or recheck the supply and take-up path.
Alternating red and green · repeated long tones
This is an RS-232C communication error. Check the serial port and both ends’ settings.

If the built-in test looks right and only PC jobs fail, check the CL-E331 300 dpi queue, port, label dimensions and TT or DT setting. Choose the CL-E331 driver

User manual, pp. 127–128

Official Citizen sources