This English quick guide is based on the Korean catalog. Confirm model-specific compatibility and installation details on the manufacturer’s official page.
Download TSP654II driver
- Match the full model number on the device label, including suffixes.
- Check your operating-system version and architecture on the official support page.
- Cancel pending print jobs before replacing an existing driver.
- Follow the manufacturer’s instructions for power, USB, and network connections.
Model and driver source
This guide is for the direct thermal receipt/pos printer, tsp650ii series; interfaces vary by configuration model Star Micronics TSP654II. The download button opens the official Star Micronics support page in this window. The manufacturer’s page is authoritative for the available driver packages and their current compatibility.
Operating-system and download checks
The Korean catalog lists these systems for checking: StarPRNT 3.8.1: Windows 11 x64, Windows 10/8.1/7 (32/64-bit). CUPS 4.13.0: macOS 15/14/13/12/11 and 10.15/10.14, not an established macOS 26 CUPS listing. Linux CUPS 3.17.0: RHEL 9.5 x64, Ubuntu 16.04 LTS 32-bit and 24.04 LTS x64; Chrome OS V134.. Select your exact operating system and version on the official page. If your version is not offered, do not install a package intended for a different system.
Connection and installation
- Check the exact TSP654II label and installed interface. It is not a scanner or the separate SK label configuration. Prepare specified power, thermal paper, guide, and matching print width.
- For Windows USB, keep the cable disconnected until the StarPRNT driver is fully installed. Extract the Full package and run Setup in the setup folder, or run the Setup EXE; choose Typical, Install, Finish.
- Turn on the printer and connect USB to let Plug-and-Play add it. Check the actual device under Printers and scanners and test print.
- For LAN, connect Ethernet and read Current IP Parameters on the self-test. In Printer Utility Star PRNT select the model, Ethernet, Search Network, or enter its actual IP. Use Windows Printer Queue Management, Install Driver, Add, and Test Print.
- Wi-Fi dongle setup applies only to an IFBD-HI01X/02X interface with a supported dongle. Start via Ethernet and the Network Utility Page at the self-test IP; use Wireless Connection, Site Survey, SSID/password, Save, and Restart device. Change and safeguard management credentials. The guide specifies 2.4 GHz and WPA2/AES. Verify Wireless Status, disconnect Ethernet, read the wireless self-test IP, then add it using the Ethernet interface selection in the utility.
- Do not assume USB, LAN, WLAN, or AirPrint are all standard on every unit. Peripheral drive connectors are not telephone connections.
Star Micronics TSP654II not printing: check possible causes
Features and interfaces vary by model. This is a general diagnostic sequence; confirm Wi-Fi, scanning, AirPrint and error-code instructions in the model manual.
| Possible cause | First checks | Help |
|---|---|---|
| Device, paper or supplies | Check the device display and supported self-test. | Check steps |
| USB detection and cable | Compare cable and port, then follow the model installation sequence. | Check steps |
| Offline or network address | Check the supported connection method and current address. | Check steps |
| Print queue or spooler | Check the first failed job and queue pause status. | Check steps |
| Model, driver or OS mismatch | If the connection works but computer printing fails, match the model and OS. | Open this model driver guide |
| Blank pages or quality settings | Compare device-only and computer output. | Check steps |